The expression long-lasting appears on many antimicrobial technology data sheets, and its meaning depends on the product. A bottle goes through repeated washing, a fabric through wash and dry cycles, a coating through years of cleaning and exposure to the environment. To decide on a technology, R&D and Quality teams need to see durability proven under the conditions of their own use.
In this article, you will learn about the factors that reduce durability and protection over time, a six-step evaluation plan and the questions that help compare suppliers.
Four factors that reduce protection over time
|
Factor
|
Where it appears
|
Corresponding aging test
|
|
Cleaning and washing
|
Wash cycles of textiles and utensils, cleaning agents on surfaces
|
Wash or cleaning cycles with the products used in the field
|
|
Abrasion and wear
|
Friction from daily use, scrubbing on coatings
|
Abrasion or scrub resistance test
|
|
Light, heat and humidity
|
Sun exposure, storage, damp areas
|
Accelerated aging in a chamber, with controlled radiation, temperature and humidity
|
|
Contact with liquids
|
Immersion, water, sweat, food
|
Immersion and extraction, with analysis of what is released from the material
|
Where the technology sits in the material
The position of the technology influences its duration. When it is incorporated into the material matrix, as in polymers and paints, it accompanies the product throughout use and depends less on a surface layer. When it is applied to the surface, as in textile finishes and coatings, adhesion and resistance to wear carry more weight. According to the description of Nanox Clean, the vertical’s solutions are based on stable materials and have a lasting action, without compromising material performance.
Six-step evaluation plan
- Define the reference service life and the acceptance criterion: the specification indicates how many cycles of use, washing or years of exposure the product must sustain and what reduction in microorganisms is expected.
- Test the new material: the time-zero result serves as the starting point, using the same standard that will be used later.
- Age the samples according to real use: washing, abrasion, light, heat, humidity or immersion, in stages.
- Repeat the efficacy test at each stage: the laboratory records the reduction relative to the untreated control.
- Evaluate the final properties: color, appearance, hand feel and mechanical strength accompany the efficacy tests.
- Confirm in a pilot batch or real use: validation under field conditions completes the data set.
Questions to ask the supplier
- What reference service life is considered for the application?
- Which aging tests were performed, and with how many cycles or how much exposure time?
- Was the efficacy test repeated after aging, using the same standard as for the new material?
- Is the technology incorporated into the matrix or applied to the surface?
- Is there data on material properties after aging?
- Are there results from a pilot batch or real use?
Frequently asked questions
Is there a standard duration for antimicrobial protection?
Duration depends on the material, the technology and the use. The market compares the performance measured after the aging defined for each application.
Does a test report on new material prove long-lasting performance?
The report on new material shows the starting point. Long-lasting performance is proven with tests repeated after washing, abrasion or aging.
Who defines the acceptance criterion?
The criterion is stated in the product specification and considers the test standard, the destination market and the intended use.
Next steps for your company
The first step is to record the expected service life of the product and the most severe conditions of use, which guide the choice of aging tests.